HOW TO RECOVERY YU HARD BRICK IN VERY EASY WAY

Files required:

View attachment 12297

hi if you have those files then follow this...

please note that the following are UNOFFICIAL steps and these will not be supported officially...

Setting up

1. Install QPST (2.7.422) tool - We will be using the QFIL tool which is part of QPST package

2. Install the Qualcomm Download Mode Driver 9008 on Windows PC

a. The required drivers are in the folder QualcommDownloadModeDriver_9008​

b. For 32-bit Windows OS open Allx86 & double click on dpinst32.exe to start the driver installer

(accept all prompts)

c. For 64-bit Windows OS open Allx64 & double click on dpinst32.exe to start the driver installer

(accept all prompts)​

Boot YUREKA to Qualcomm HS-USB QDLoader 9008 mode

Step 1] Power off the device/remove the battery and the re-insert after few seconds.

Step 2] Open the back cover, unscrew all the screws for the inner cover. Pry open the inner cover to

expose the 6 tap points next to the headset plug.

View attachment 12296

Step 3] With the battery connected, short the top two tap points on the right side.

This is illustrated in the attached image.

Step 4] With the two tap points shorted, plugin the USB cable. The device will enter (9008) QDL mode. If

the Qualcomm driver is installed correctly, the device will show up as a serial device.

View attachment 12294

Flashing YUREKA Hard-brick Recovery files in Qualcomm HS-USB QDLoader 9008 mode

Step 1] The files needed for low level device recovery are in the YUREKA_Bootloader_Recovery folder.

Step 2] Open the QFIL tool, if you complete previous steps correctly, it will detect the device

as: Qualcomm HS-USB QDLoader 9008 (COMx)

View attachment 12295

Step 3] In Select Programmer path browser to the folder with those files and

select: prog_emmc_firehose_8936.mbn

Step 4] The Select Build section will automatically select the base folder with those files

Step 5] Now click on Load XML

Step 6] First you will be asked to select the RawProgram file, browse to the folder with those files and

select rawprogram0.xml

Step 7] Next you will be asked to select the Patch file, browse to the folder with those files and

select patch0.xml

Step 8] Finally click on “Download” to start the flashing process.

Step 9] Keep watching the Status log.

After flashing is over the following status log will be shown:

PATCH: Partition 0, Sector: 1, Offset 16 Bytes, Size: 4 Bytes, Value: CRC32(1,92)

PATCH: Partition 0, Sector: 0, Offset 16 Bytes, Size: 4 Bytes, Value: 0

PATCH: Partition 0, Sector: 0, Offset 16 Bytes, Size: 4 Bytes, Value: CRC32(NUM_DISK_SECTORS-

1.,92)

Total download file size: 52.9502MB

Throughput: 10.59004M/s

Reset Phone

Waiting for reset done...

Step 10] The device will now boot and get stuck at the YU boot logo! The device will be continuously

vibrating

Step 11] Congratulations the device is now revived!

Step 12] Close the QFIL program

Step 13] Disconnect the device and remove the battery for few seconds

Step 14] Reinsert the battery and now keeping the VOLUME UP button pressed connect device to PC –

this will trigger FASTBOOT mode

Step 15] Now flash Lollipop (64-bit) factory images via fastboot!